Remove the clutch cover
All bolts are 10 MM

Remove the bolts from the cover
Bolts are again 10MM



Remove the center bolt - Threads are LEFT HAND
Use an air gun if you have one



Pull the spring cover and spring off


Thread the clutch puller into the clutch.

Tighten the puller until the primary pulley pops off.

Remove the primary clutch and the belt.
Put the primary back on to work on it

Hold one of the nuts with a wrench
Pull the nut on the other side off

Pull the pin all the way out
Use a small punch to drive it out if you need to


Fish the weight out with a small set of pliers

Hold the new weight with a small set of pliers
Work the pin through the hole in the weight

Slide the clutch off and install the belt.
Slide the primary back on.

Put your clutch spring in
Now is a good time to put on a Dalton Overdrive Cover