Drain the coolant
Remove the logo cover
Remove the center bolt - 19mm
Remove the temperature sensor wire and move it out of the way
Remove the 4 bolts to the impeller housing
Use a small socket to remove the impeller - 10mm
Loosen all bolts on the housing - 8mm
Carefully remove the housing
Remove the center bearing
Using a flywheel puller, remove the flywheel and the starter gear.
Remove the old flywheel key.
Insert the new key with the cutout facing towards the rear wheels.
Reinstall everything in reverse order.
If you don't use a new gasket, use a light coating of Permatex.
Now find the nearest Raptor and teach him a little lesson.
